Regional groundwater summary • British Columbia Historical Log Extraction
Bottom Line Up Front
In Lantzville, the median completed well is 175 ft deep.
A published hardness range for this place and aquifer is less than 10 to 180, and groundwater can exceed 1,000 mg/L as CaCO₃. That is a regional estimate, not a test of your well. Source: Estimate based on B.C. Ministry of Environment water-quality checks.
Most production draws from Unconsolidated (about 23% of local wells).
These municipal aggregates support planning only — they do not replace an accredited laboratory potability test for your own well.
Interactive Well Depth & Modeled Typical Strata
Drag the indicator line or tap a stratum below to read the recorded depth range
Modelled Depth
175 FT
Area median
Drilling cost
$12,250–$26,250
Estimate
Published hardness
less than 10 to 180, and groundwater can exceed 1,000 mg/L as CaCO₃
Modeled typical strata — placeholder from median depth + aquifer type; not local driller logs.
Local measurements compared against British Columbia provincial benchmarks.
| Hydrogeological Metric | From the registry or a cited study | BC Provincial Benchmark |
|---|---|---|
| Total Registered Wells | 250 | — |
| Median Well Depth | 175 ft | 162 ft provincial median |
| Average Well Depth | 221.0 ft | — |
| Dominant Aquifer | Unconsolidated | — |
| Hardness | less than 10 to 180, and groundwater can exceed 1,000 mg/L as CaCO₃ — Estimate. Estimate based on B.C. Ministry of Environment water-quality checks | — |
| Drilling cost | $12,250–$26,250 — Estimate. Typical drilling prices in Canada, about $70–$150 per foot | — |
| Domestic Household Use | 90% of wells | — |
Approximate boundary of Lantzville
Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire Lantzville.
Most completed wells fall near the median depth of 175 ft. Recorded depths cover 246 wells.
Median depth of 175 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.
Bedrock and drift aquifers recorded by drillers in this area. Recorded for 102 of these 250 wells.
58 of 250 Unclassified hydrogeological formation from legacy provincial drill records.
44 of 250 Major regional bedrock aquifer formed by Ordovician/Silurian dolomite. Known for reliable, high-volume yields with elevated mineral hardness and dissolved calcium/magnesium carbonates.
14 holes found no usable water. test holes, observation or monitoring wells, dewatering wells, decommissioned wells, dry holes, no-aquifer holes, and other non-supply wells filtered out of the headline
A published hardness range, when one exists for this place and aquifer. Not a test of your well.
Measured nearby
Measured government tests within 25 km of Lantzville.
USGS (2018) bands reprinted by Health Canada. A range can cross more than one band. This is not a sample.
What this is not
Health Canada has not set a maximum acceptable concentration for hardness. A wide published range can sit in more than one USGS band.
OBS WELL 232 - LANTZVILLE (HARBY RD.), 1.09 km away, nearby.
6 government lab tests, dated 1988–2015.
Hardness 8–100 mg/L as CaCO₃, median 80.8.
Worked out by wellwaterguide.ca from 6 government lab tests.
reported hardness, or calculated from measured calcium and magnesium when hardness was not reported
BC Environmental Monitoring Data System (EnMoDS) results: Provincial Groundwater Observation Well Network wells Open Government Licence - British Columbia
OBS WELL 340 - LANTZVILLE (VALMAR ROAD), 2.37 km away, nearby.
5 government lab tests, dated 2000–2016.
Hardness 45–101 mg/L as CaCO₃, median 83.7.
Worked out by wellwaterguide.ca from 5 government lab tests.
reported hardness, or calculated from measured calcium and magnesium when hardness was not reported
BC Environmental Monitoring Data System (EnMoDS) results: Provincial Groundwater Observation Well Network wells Open Government Licence - British Columbia
OBS WELL 392 - NANOOSE (DAWSON RD DEEP), 11.49 km away, in the wider area.
4 government lab tests, dated 2011–2016.
Hardness 182–208 mg/L as CaCO₃, median 195.5.
Worked out by wellwaterguide.ca from 4 government lab tests.
reported hardness, or calculated from measured calcium and magnesium when hardness was not reported
BC Environmental Monitoring Data System (EnMoDS) results: Provincial Groundwater Observation Well Network wells Open Government Licence - British Columbia
9 wells tested, range 4–1,420 mg/L.
8.25 km away, nearby.
Tests dated 1988–2017.
3 wells test above 180 mg/L.
Worked out by wellwaterguide.ca from 13 government lab tests.
reported hardness, or calculated from measured calcium and magnesium when hardness was not reported
BC Environmental Monitoring Data System (EnMoDS) results: Provincial Groundwater Observation Well Network wells Open Government Licence - British Columbia
Historical permit and construction activity by decade.
Treatment
This page does not turn a hardness range or a well depth into an equipment total, a grain capacity, or a drilling price. Read the methodology, the filtration guide, and the products catalog.
Suggested system
Test kit
estimate, confirm with a lab testA test of your own well comes before any equipment. Test for coliform bacteria.
Water testingSediment prefilter
estimate, confirm with a lab testA sediment prefilter is worth considering where wells draw from Unconsolidated. This follows the aquifer type.
Sediment guideIron and manganese filter
estimate, confirm with a lab testManganese above the aesthetic objective, consider an iron/manganese filter. A monitoring well near this place has median manganese of 0.0297 mg/L.
Iron and manganese guideUV disinfection
estimate, confirm with a lab testUV disinfection is worth considering where wells draw from Unconsolidated. Test for coliform bacteria. This follows the aquifer type.
Bacteria and UV guideBecause water wells in Lantzville average 175 ft into unconsolidated, contractors equipped with heavy rotary rigs and proper casing seals are recommended. Contact local drillers directly or request competitive bids.
Yard: Duncan, BC (60.7 km away)
Yard: Cumberland, BC (79.6 km away)
Yard: Abbotsford, BC (129.1 km away)
Yard: Chilliwack, BC (159.9 km away)
Looking for more regional well drillers?
Explore all registered water well contractors operating across BC.
Featured Contractor Spot
Claim your verified listing profile and be found by homeowners on this report.
Quick answers about water wells in Lantzville.
Among 246 producing water wells with a recorded depth, the median is 175.0 ft (53.34 m).
The most frequently recorded producing aquifer is Unconsolidated, on 58 of 102 wells with a producing aquifer name.
Explore neighbouring hydrogeological formations and compare drilling depths