Canada's Well Water Guide
Loading regions
Ontario • 10,132 Registered Wells

Oxford Water Well Depth & Hydrogeology

Regional groundwater summary • Ontario Historical Log Extraction

Bottom Line Up Front

In Oxford, the median completed well is 104 ft deep.

A published hardness range for this place and aquifer is under 60 to above 180 mg/L as CaCO₃. That is a regional estimate, not a test of your well. Source: Estimate based on Health Canada hardness bands.

Most production draws from Limestone (about 51% of local wells).

These municipal aggregates support planning only — they do not replace an accredited laboratory potability test for your own well.

Interactive Well Depth & Modeled Typical Strata

Drag the indicator line or tap a stratum below to read the recorded depth range

Drilling in: Sand & Gravel Aquifer (20–400+ ft)Glacial Drift Aquifer

Modelled Depth

104 FT

Area median

Drilling cost

$7,280–$15,600

Estimate

Published hardness

under 60 to above 180 mg/L as CaCO₃

0 ft (Surface)Median 104 ft400 ft (Deep)
Topsoil & Surficial Organics
Sand & Gravel Aquifer
Sand & Gravel Aquifer
Modeled typical strata:

Modeled typical strata — placeholder from median depth + aquifer type; not local driller logs.

Well Statistics

Local measurements compared against Ontario provincial benchmarks.

Total Registered Wells 10,132
Median Well Depth 104 ft
ON benchmark: 103 ft provincial median
Average Well Depth 113.1 ft
Dominant Aquifer Limestone
Hardness under 60 to above 180 mg/L as CaCO₃ — Estimate. Estimate based on Health Canada hardness bands
Drilling cost $7,280–$15,600 — Estimate. Typical drilling prices in Canada, about $70–$150 per foot
Domestic Household Use 71% of wells

Where This Report Applies

Approximate boundary of Oxford

Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire Oxford.

Depth Distribution

Most completed wells fall near the median depth of 104 ft. Recorded depths cover 9,973 wells.

0–49 ft 20.4% · 2,038
49–98 ft 26.6% · 2,655
98–148 ft 25.6% · 2,554
148–197 ft 15.2% · 1,517
197–295 ft 10.2% · 1,022
295–394 ft 1.5% · 150
394–591 ft 0.3% · 34
591+ ft 0% · 3

Median depth of 104 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.

Aquifer Composition

Bedrock and drift aquifers recorded by drillers in this area. Recorded for 9,926 of these 10,132 wells.

Carbonate Bedrock (Limestone / Dolomite) Primary Bedrock Aquifer
50.7%

5,138 of 10,132 Major regional bedrock aquifer formed by Ordovician/Silurian dolomite. Known for reliable, high-volume yields with elevated mineral hardness and dissolved calcium/magnesium carbonates.

Sand & Gravel Aquifer Glacial Drift Aquifer
35.9%

3,637 of 10,132 Shallow to intermediate glacial drift aquifer deposited in alluvial channels or outwash plains. Yields softer water but requires continuous sediment filtration and shallow bacterial monitoring.

Glacial Lacustrine Clay & Silt Confining Aquitard
8.8%

894 of 10,132 Impermeable glaciolacustrine clay and silt deposits formed in ancient glacial lakes. Acts as an effective regional aquitard confining underlying aquifers.

Sedimentary Shale Formation Fractured Shale Aquifer
2.4%

245 of 10,132 Fractured sedimentary shale formation (including Odanah / Pierre members). Characterized by high total dissolved solids (TDS) and potential sulfur/iron compounds.

Sandstone Bedrock Formation Basal Bedrock Aquifer
0.1%

8 of 10,132 Deep basal sandstone bedrock unit (including Winnipeg Formation). Supplies exceptionally stable yields; often exhibits moderate mineral hardness with silica-rich water.

Precambrian Crystalline Bedrock (Granite) Crystalline Bedrock Aquifer
0%

4 of 10,132 Crystalline Canadian Shield rock. Yields soft, slightly acidic water with minimal dissolved solids, relying on secondary fracture networks for groundwater storage.

4,145 holes found no usable water. test holes, observation or monitoring wells, dewatering wells, decommissioned wells, dry holes, no-aquifer holes, and other non-supply wells filtered out of the headline

Water Quality Profile

A published hardness range, when one exists for this place and aquifer. Not a test of your well.

Measured nearby

Measured government tests within 25 km of Oxford.

Soft (<60) Med (61–120) Hard (121–180) V. hard (>180)

USGS (2018) bands reprinted by Health Canada. A range can cross more than one band. This is not a sample.

What this is not

  • Not a laboratory result for a well on your property.
  • Not a reason to size a softener. Size equipment from a lab test.
  • Not a drilling quote. A cost line on this page is a national estimate, not a price for one well.

Health Canada has not set a maximum acceptable concentration for hardness. A wide published range can sit in more than one USGS band.

1 well tested, range 227–239 mg/L.

22.49 km away, in the wider area.

Tests dated 2002–2009.

These results are old (tested 2002–2009).

1 well tests above 180 mg/L.

Worked out by wellwaterguide.ca from 2 government lab tests.

reported hardness, or calculated from measured calcium and magnesium when hardness was not reported

Provincial Groundwater Monitoring Network (PGMN): water chemistry and well locations Open Government Licence - Ontario

Drilling Activity

Historical permit and construction activity by decade.

Pre-1970 2,702 wells
1970s 2,039 wells
1980s 1,430 wells
1990s 1,277 wells
2000s 1,045 wells
2010s 945 wells
2020s 684 wells

67% of dated wells are over 30 years old (pre-1995). Steel casing installed before 1995 can lose integrity over time. Any older well should get a casing inspection and a certified bacterial test before reliance.

Treatment

Size treatment from a laboratory test

This page does not turn a hardness range or a well depth into an equipment total, a grain capacity, or a drilling price. Read the methodology, the filtration guide, and the products catalog.

Suggested system

Suggested system for Oxford

1

Test kit

estimate, confirm with a lab test

A test of your own well comes before any equipment. Test for coliform bacteria.

Water testing
2

Iron and manganese filter

estimate, confirm with a lab test

Manganese above the aesthetic objective, consider an iron/manganese filter. One monitoring well near this place has median iron of 1.15 mg/L and median manganese of 0.1125 mg/L. Another has median iron of 1.89 mg/L and median manganese of 0.0368 mg/L. Another has median manganese of 0.0241 mg/L.

Iron and manganese guide
3

Water softener

estimate, confirm with a lab test

A softener is likely needed. The nearest monitoring well has a median hardness of 341 mg/L as CaCO₃.

Hard-water guide
Local Contractors

Licensed Water Well Drillers Serving Oxford

Because water wells in Oxford average 104 ft into limestone, contractors equipped with heavy rotary rigs and proper casing seals are recommended. Contact local drillers directly or request competitive bids.

SD Hopper Drilling

Yard: Stratford, ON (35.2 km away)

Serves Oxford
Confirm the contractor's provincial licence before you hire
Farm & Livestock Wells Domestic Well Drilling Downhole Camera

Stainton's Ltd Pumps & Well Drilling

Yard: Arva, ON (41.1 km away)

Serves Oxford
Confirm the contractor's provincial licence before you hire
Cable Tool & Rotary Drilling Water Treatment Systems Bored Wells

Jim Wilson Well Drilling Ltd.

Yard: Waterloo, ON (50.6 km away)

Confirm the contractor's provincial licence before you hire
Rotary Air & Mud Drilling Commercial High Yield Decommissioning

VanDerZalm Well Drilling

Yard: Niagara-on-the-Lake, ON (133.6 km away)

Confirm the contractor's provincial licence before you hire
Niagara Escarpment Formations Vineyard & Farm Irrigation Residential Wells

Looking for more regional well drillers?

Explore all registered water well contractors operating across ON.

Featured Contractor Spot

Are you a licensed well driller serving Oxford?

Claim your verified listing profile and be found by homeowners on this report.

Claim Local Listing

Frequently Asked Questions

Quick answers about water wells in Oxford.

What is the median well depth in Oxford?

Among 9973 producing water wells with a recorded depth, the median is 104.0 ft (31.7 m).

Adjacent Municipalities & Nearby Well Records

Explore neighbouring hydrogeological formations and compare drilling depths

Nearby communities