Regional groundwater summary • Saskatchewan Historical Log Extraction
Bottom Line Up Front
In RM of Aberdeen No. 373, the median completed well is 54 ft deep.
A published hardness range for this place and aquifer is under 60 to above 180 mg/L as CaCO₃. That is a regional estimate, not a test of your well. Source: Estimate based on Health Canada hardness bands.
Most production draws from 10 (about 16% of local wells).
These municipal aggregates support planning only — they do not replace an accredited laboratory potability test for your own well.
Interactive Well Depth & Modeled Typical Strata
Drag the indicator line or tap a stratum below to read the recorded depth range
Modelled Depth
54 FT
Area median
Drilling cost
$3,780–$8,100
Estimate
Published hardness
under 60 to above 180 mg/L as CaCO₃
Modeled typical strata — placeholder from median depth + aquifer type; not local driller logs.
Local measurements compared against Saskatchewan provincial benchmarks.
| Hydrogeological Metric | From the registry or a cited study | SK Provincial Benchmark |
|---|---|---|
| Total Registered Wells | 323 | — |
| Median Well Depth | 54 ft | 89 ft provincial median |
| Average Well Depth | 103.4 ft | — |
| Recorded Depth Range | 8 – 480 ft | — |
| Dominant Aquifer | 10 | — |
| Hardness | under 60 to above 180 mg/L as CaCO₃ — Estimate. Estimate based on Health Canada hardness bands | — |
| Drilling cost | $3,780–$8,100 — Estimate. Typical drilling prices in Canada, about $70–$150 per foot | — |
| Domestic Household Use | 97% of wells | — |
Approximate boundary of RM of Aberdeen No. 373
Shaded area is an approximate municipal outline for orientation only. Well records are aggregated across the entire RM of Aberdeen No. 373.
Most completed wells fall near the median depth of 54 ft. Recorded depths cover 321 wells.
Median depth of 54 ft falls inside the reported range. Deeper completions here usually mean higher mineral content but steadier year-round pressure.
Bedrock and drift aquifers recorded by drillers in this area. Recorded for 51 of these 323 wells.
51 of 323 Unclassified hydrogeological formation from legacy provincial drill records.
131 holes found no usable water. test holes, observation or monitoring wells, dewatering wells, decommissioned wells, dry holes, no-aquifer holes, and other non-supply wells filtered out of the headline
A published hardness range, when one exists for this place and aquifer. Not a test of your well.
Measured nearby
Measured government tests within 25 km of RM of Aberdeen No. 373.
USGS (2018) bands reprinted by Health Canada. A range can cross more than one band. This is not a sample.
What this is not
Health Canada has not set a maximum acceptable concentration for hardness. A wide published range can sit in more than one USGS band.
SWA Saskatoon, 19.62 km away, in the wider area.
6 government lab tests, dated 1967–2005.
These results are old (tested 1967–2005).
Hardness 1,850–2,080 mg/L as CaCO₃, median 1,978.5.
Worked out by wellwaterguide.ca from 6 government lab tests.
reported hardness (as CaCO3)
Saskatchewan observation well network: water-quality results Public data. Water Security Agency confirmed in writing on 2026-10-20 that published observation-well data is public for public use.
SWA Hague, 24.11 km away, in the wider area.
6 government lab tests, dated 1966–2005.
These results are old (tested 1966–2005).
Hardness 508–702 mg/L as CaCO₃, median 656.5.
Worked out by wellwaterguide.ca from 6 government lab tests.
reported hardness (as CaCO3)
Saskatchewan observation well network: water-quality results Public data. Water Security Agency confirmed in writing on 2026-10-20 that published observation-well data is public for public use.
Water in a provincial observation well isn't necessarily representative of nearby private wells.
Historical permit and construction activity by decade.
67% of dated wells are over 30 years old (pre-1995). Steel casing installed before 1995 can lose integrity over time. Any older well should get a casing inspection and a certified bacterial test before reliance.
Treatment
This page does not turn a hardness range or a well depth into an equipment total, a grain capacity, or a drilling price. Read the methodology, the filtration guide, and the products catalog.
Suggested system
Test kit
estimate, confirm with a lab testA test of your own well comes before any equipment. Test for coliform bacteria.
Water testingIron and manganese filter
estimate, confirm with a lab testManganese above the aesthetic objective, consider an iron/manganese filter. One monitoring well near this place has median iron of 14.45 mg/L and median manganese of 0.285 mg/L. Another has median iron of 5.15 mg/L and median manganese of 0.0745 mg/L.
Iron and manganese guideWater softener
estimate, confirm with a lab testA softener is likely needed. The nearest monitoring well has a median hardness of 1,978.5 mg/L as CaCO₃.
Hard-water guideBecause water wells in RM of Aberdeen No. 373 average 54 ft into 10, contractors equipped with heavy rotary rigs and proper casing seals are recommended. Contact local drillers directly or request competitive bids.
Yard: Saskatoon, SK (25.7 km away)
Yard: Saskatoon, SK (27.1 km away)
Yard: Humboldt, SK (81.8 km away)
Yard: Prince Albert, SK (107.1 km away)
Looking for more regional well drillers?
Explore all registered water well contractors operating across SK.
Featured Contractor Spot
Claim your verified listing profile and be found by homeowners on this report.
Quick answers about water wells in RM of Aberdeen No. 373.
Among 321 producing water wells with a recorded depth, the median is 54.0 ft (16.4592 m).
The most frequently recorded producing aquifer is 10, on 51 of 51 wells with a producing aquifer name.
Explore neighbouring hydrogeological formations and compare drilling depths